You may also receive a security warning. Be patient.. And, using other programs during the download will slow down the process. Step 3 — Take the USB drive with the software updates to your vehicle. Turn on your vehicle, and then turn on the radio. Make sure your car is in a well-ventilated area. Your vehicle will need to be turned on, with the engine running between 25 to 35 minutes.
Make sure that your vehicle is not in Accessory mode. The system should start the download process within a few seconds…. With the MyFord Touch system, now let your vehicle run and the entire download process takes about 25 minutes.
While the process is going on, remove the SYNC system from your phone or device. Put your key in the car and turn it to the On position the first click after off. Do not put it in accessory mode, which is the second click. Start up Forscan. You should be on the Vehicle and Interface Information screen the icon looks like a car with an 'i' in a yellow circle on top of it.
Click on the icon that looks like two power cables plugged in to each other to connect to your car. You'll see some information start to populate the log. Wait until it is completely finished. Forscan might show you a menu with different vehicle options to pick. Pick yours from the list. If at any time Forscan asks if you want to save something so you can back it up later, say yes.
Click on the icon that looks like a microchip and under the Configuration and Programming tab, select APIM and press the play icon. You'll see a lot of fields that are labeled with numbers that start with 7D0. Click the disk icon at the bottom of the screen to save a copy of these original values. Find 7D and change the first two numbers in the first field from 00 to Click Write to save the change.
You'll see a warning message about the checksum being bad. Click yes to ignore it and continue with the change. Go back to the Vehicle and Interface Information screen the icon looks like a car with an 'i' in a yellow circle on top of it and click the unplugged power cables icon to disconnect your computer from the car.
You can remove the OBD2 interface now if you like. Put the navipatch. Click on Add, and select your USB drive. Highlight the navipatch. Go back to the Vehicle and Interface Information screen the icon looks like a car with an 'i' in a yellow circle on top of it and click the unplugged power cables icon to disconnect your computer from the car. You can remove the OBD2 interface now if you like. Put the navipatch. Click on Add, and select your USB drive. Highlight the navipatch. Press it, and you should see 'nav enabled' appear above it.
If you're okay with doing a master reset, do that now and you should see the navigation functions when it's done. Look for the 'i' icon that will appear to the right of the home screen icon on MyFord Touch. Post navigation Free 3ds Model Download Toyota 4runner.
0コメント